Q&A / 

Vintage Tub

Vintage Tub

Here's a vintage tub look-a-like. The only thing missing that would create the illusion that this is a 120-year-old vintage tub are the claw feet. Copyright 2018 Tim Carter

"The biggest things you have to take into consideration are the rough-in locations for the gorgeous exposed drain piping and the decorative water supply lines."

Vintage Tub Checklist

  • The floor must support concentrated loads
  • Rough-in for water and drain lines is critical
  • Subflooring should be treated with borate chemicals
  • Install a waterproof membrane for water sports accidents

Related Links

Bathroom Remodeling - What Happens When? SECRET Information - Do NOT Share

Tub Faucets - FREE Pro Tips

Free & Fast Bids

CLICK HERE to get FREE & FAST BIDS from local plumbers.

DEAR TIM: I just bought a home with a large bathroom that’s perfectly suited for a vintage tub. Are the plumbing requirements any different for these fixtures as opposed to standard built-in tubs and showers?

If you were installing a vintage tub and bath at your home, what would you do to make sure there were no problems from water that might splash out of the tub? Any other bathroom remodeling tips would be sincerely appreciated. Rochelle D., Washington DC

Vintage Tub - Looks & Feels Great But Practical?

DEAR ROCHELLE: I never quite understood the attraction of a vintage bathtub until I sat in one years ago when we were about to remove from an old home. It was after lunch and I almost fell asleep in the mammoth vessel, it was so comfortable. Whoever designed it made sure the slope of the tub back and height of the side walls perfectly fit the average body. Total relaxation set in within seconds of me sitting in the tub and putting my arms up on the sides of that vintage clawfoot tub.

What Are the Plumbing Requirements for a Vintage Tub?

If you decide to install one of these magnificent plumbing fixtures, I’ve got good news. There are no extraordinary plumbing requirements for the tub. The biggest things you have to take into consideration are the rough-in locations for the gorgeous exposed drain piping and the decorative water supply lines. These need to be precisely positioned so they are plumb and centered with the tub. A good plumber can do this with little effort.

Does the Floor Have to Be Strong?

A bigger concern, in my opinion, is the subfloor framing. A vintage tub bath fixture produces concentrated loads at the four locations where the feet touch the floor. A standard built-in tub that’s properly supported usually transfers its weight to the side wall and along the entire edge of the tub skirt. Some built-in tubs have a rigid foam pad under them that helps distribute the load over the entire floor beneath the tub.

How Do You Prevent Floor Sag?

I would install vertical blocking directly under the location of each foot of the vintage tub and bath you’re installing. This blocking consists of a short piece of floor joist that’s nailed between two other full-length floor joists. This blocking prevents the subfloor sheathing from sagging under the weight of the tub when it’s loaded with water and a bather.

Can Water Splash Out of the Tub?

Water can splash out of these tubs if kids are in them or if you have a pseudo-vintage pedestal bathtub like mine. My tub has a built-in whirlpool feature. When the bubbler is on high, it does splash water out of the tub.

Is a Ceramic Tile Floor Waterproof?

Many people think that a ceramic tile floor is waterproof. Most tiles are waterproof, but the grout lines between each tile are not. Water can seep through a grout joint and over time cause wood rot under a tub.

CLICK HERE to get FREE & FAST BIDS from local plumbers.

How Can I Prevent Wood Subfloor Rot?

You can treat regular wood with a borate solution that is safe for humans but’s toxic to a wide majority of wood fungi that are responsible for wood rot.

borate wood treatment

This is borate wood treatment. It's a powder you mix with water. CLICK THE PHOTO now to have it delivered to your home in two days.

You may want to spray the floor joists several times with this solution as well as saturate the subfloor sheathing on both the top and underside. When the borate solution dries, it does a great job of protecting regular lumber.

What Membrane Can I Install Over the Wood?

You can also install 30-pound felt paper on top of the subfloor before the cement-based tile underlayment is installed. I’d overlap the felt seams no less than 9 inches. This felt can extend over the entire subfloor of the bathroom and turn up several inches where it touches the walls. It’s a great line of defense for any water that saturates the cement underlayment.

What Diameter Should the Water Lines Be?

Be sure the water supply lines that feed the tub faucet are at least 3/4-inch in diameter. Vintage tub faucets often are designed to allow for a heavy flow of water so the tub fills quickly. If you have 1/2-inch supply lines and normal water pressure, the tub can take a considerable amount of time to fill.

How Wide Should the Bathroom Door Be?

As crazy as this sounds, make sure the door into the bathroom is wide enough to allow you to bring in the tub to the room after the finished floor is installed and the room is basically finished. I'd have a 32-inch-wide door for the bathroom.

When are Vintage Tubs Installed?

Built-in tubs are installed during rough construction when doors and door frames are just a gleam in the eye of the finish carpenter. Vintage tubs are installed at the end of the job after the bathroom is completely finished. Believe me when I tell you that more than one bathroom doorway has had to be altered to get a vintage bathtub into a room!

Should I Install a Special Vent Fan?

Consider installing a remote bathroom exhaust fan in this new bathroom. These are very quiet and will allow you to vegetate in the tub without the pesky drone of a standard bathroom exhaust fan.

fantech bath fan

This is a fantastic remote bath fan. It's very very quiet because the fan motor is far away from the hole in the ceiling. CLICK THE PHOTO to have the kit at your home in days.

Remote fans gently vacuum all of the water vapor produced by the steaming bath out of the room and through the roof of your home. Place the fan inlet over the tub. Many come with an accessory light to illuminate the tub. You can connect two inlets to the same fan allowing you to fully ventilate the bathroom.

CLICK HERE to get FREE & FAST BIDS from local plumbers.

Column 837

Summary
A Vintage Tub is Comfy but Splashy Too! | AsktheBuilder.com
Article Name
A Vintage Tub is Comfy but Splashy Too! | AsktheBuilder.com
Description
A vintage tub is very comfortable. But water can splash out with ease. Be sure the floor is strong and waterproof. Great videos here.
Author
Publisher Name
AsktheBuilder.com
Publisher Logo
SPONSORS / 

2 Responses to Vintage Tub

Leave a Reply

You have to agree to the comment policy.