Q&A / 

How to Flash Siding Block

flash siding block

How to Flash Siding Block | This siding block is suffering from wood rot. One of the reasons could be it lacks proper side and bottom flashings. Look at the giant gap on the right where caulk is missing. Copyright 2020 Tim Carter

How to Flash Siding Block - You Need Thin Stainless Steel

Watch this video to understand one correct way to flash a siding block for light fixtures, hose bibs, appliance vents, etc. It's much easier to install the special stainless steel flashing tape as you're installing the siding rather than to do a repair.

CLICK or TAP HERE to purchase the amazing stainless steel flashing you see me use in the video.

Why Must you Flash Siding Blocks?

Siding blocks require flashing because caulk almost always fails. Caulk is not a permanent weather barrier.

Look at the screenshot taken from the video showing how the caulk failed and you can see the brown water stain on the Tyvek house wrap. It's important to realize the photo below was taken AFTER the original smaller siding block was removed. It had no side nor bottom flashings.

how to flash siding block

The red arrows point to water stains on the Tyvek that happened on the right side of the old SMALLER siding block that was removed. Copyright 2020 Tim Carter

CLICK or TAP HERE to get FREE QUOTES from local handymen that can use the stainless steel flashing tape on your siding blocks.

The red arrows point to a water leak along the right side of the OLD siding block that was in place for the original faucet. This water could have caused severe rot in certain situations.

Proper flashing of the edge of the opening as the siding is installed would ensure that should the caulk fail, the water will flow out under the siding block and out onto the siding below the block.

 

SPONSORS / 

4 Responses to How to Flash Siding Block

Leave a Reply

You have to agree to the comment policy.